Clean surfaces before assembly. If possible use sandpaper before cleaning.

If curing speed is low due to inactive metal surface or high surface gap, AC-64 Anaerobic Activator should be applied to surfaces before adhesive.

Apply the adhesive to both surfaces.

Roller or brush can be used to apply adhesive.

Assembly parts and hold on for 24 hours at 22-24°C to ensure full curing of gasketing compound.

For disassembly, use hand tools to remove mating parts.

When it is hard to dissemble at room temperature, apply local heat until reaching 250°C and disassemble while hot. Then, remove any residual cured adhesive mechanically and clean parts with a proper solvent, acetone.